DVR Chatter

Discussing the DCT-6412, Home Theater Devices, Entertainment, Celebrity and the Cable Industry. Not affiliated with any Cable Company, Hardware Manufacturer or Software Developer.



You are not logged in.

-->

#1 07-04-2006 8:03:07 PM

ebaby
New member
Registered: 07-04-2006
Posts: 2
PM

Reset Comcast Remote

I accidentally programmed the tuner swap function on the channel up key.  I can't figure out how to undo the swap function.  Is there a way to reset the remote to the factory specs?

thanks for the help

Offline

 

#2 07-04-2006 10:37:46 PM

Wareagle
Charter Member
From: Bellevue, WA
Registered: 02-15-2005
Posts: 1073
PM

Re: Reset Comcast Remote

Check the manual, this section:  http://www.cjhengineering.com/hdtv/cabl … moteAC.htm

Offline

 

#3 07-05-2006 12:43:00 AM

Frank
DVR Chatter Honcho
From: Bucks, PA
Registered: 02-12-2005
Posts: 2880
PM  Website

Re: Reset Comcast Remote

From the Wikibook entry:
OPS Reset

This reset will delete all macros and keymoves. It will not reset device codes.

   1. Press and hold the "Setup" key until a device key blinks twice.
   2. Type in the code 980.
   3. If successful, a device key will blink FOUR times.

Factory Reset

This reset will delete all macros and keymoves and reset device codes to defaults.

   1. Press and hold the "Setup" key until a device key blinks twice.
   2. Type in the code 981.
   3. If successful, a device key will blink FOUR times.

Offline

 

#4 07-05-2006 10:44:05 AM

ebaby
New member
Registered: 07-04-2006
Posts: 2
PM

Re: Reset Comcast Remote

Thanks for those reset codes, Frank.

Offline

 

#5 07-05-2006 4:16:44 PM

andyross
Charter Member
From: Schaumburg, IL
Registered: 02-14-2005
Posts: 597
PM  Website

Re: Reset Comcast Remote

ebaby wrote:

I accidentally programmed the tuner swap function on the channel up key.  I can't figure out how to undo the swap function.  Is there a way to reset the remote to the factory specs?

From http://en.wikibooks.org/wiki/How_to_use … the_Remote

Restore a Remapped Key

The following technique can be used to restore the original function to a key that has been remapped. You are essentially mapping the key onto itself.

   1. Press the device key ("Cable", "TV", or "AUX") for the device you want.
   2. Press and hold the "Setup" key until the selected device button blinks twice.
   3. Type in the code 994. The selected device key will blink twice.
   4. Press the key you are restoring twice. The device key will blink twice if successful.


Sony KV-30XBR910, Sony STR-DB930, Sony DVP-NS55P, JVC HR-S3800U, Motorola DCT-6412, Sony KV-13FS100, OneForAll URC-8910.
Andy's UnEmpty Web Page
How to use a Motorola DVR

Offline

 

Board footer

Powered by PunBB
© Copyright 2002–2005 Rickard Andersson